APT ថ្នាំទ្រនាប់ស៊ីប៉ុកស៊ីលើផ្ទៃចាស់ និង ដែក PS60

KERASEAL PS60

Primer & Sealer

📝 Description

KERASEAL PS60 is a solvent-based epoxy primer and sealer designed to offer superior resistance to abrasion and mechanical stress. It offers increased adhesive strength while providing greater toughness.

📍 Key Uses

• As a primer for KERASEAL flooring systems.
• As a primer for KERAGUARD corrosion protection systems.
• Dustproofing for new and old concrete surfaces.
• Clear sealer for concrete floors.
• Improve the surface strength of concrete floors.

✨ Advantages

• Low viscosity.
• Significantly increases the strength of weak and friable surfaces.
• Provides a high mechanical bond between the substrate and finishes.
• Excellent chemical resistance.
• Restores concrete surface strength and durability.
• High penetration and glossy finish when used as a dustproofer.

📊 Technical Properties

Property	Value
Solid content	60%
Working time	60-90 mins
Surface drying time	≤6 hours
Water resistance (240 hrs)	Good
Bond strength	≥2 Mpa
Impact Strength	50 kG.cm

📏 Coverage

• On normal concrete surfaces: 0.10 - 0.12 kg/m²

Applying the Product

1. Surface Preparation

• Concrete must have a minimum compressive strength of 25 N/mm².
• The surface must be clean, dry, and free from oil and greases.
• Contaminants should be removed by specialized chemical, followed by mechanical preparation.

2. Application Conditions

• Substrate moisture content must be < 6%.
• Substrate temperature must be between +15°C and +39°C.
• Maximum relative air humidity is 85%.

3. Mixing

• Add Part B to Part A and mix for 2-3 minutes until homogeneous.

4. Application

• Can be applied by brush, short-hair roller, or airless spray.
• As a sealer/dustproofer: Apply a minimum of two coats.
• As a primer: Normally one coat is sufficient.
• Allow 24 hours for initial cure and 7 days for maximum properties. Ensure sufficient ventilation and a temperature above 20°C.

📦 Storage & Packaging

• Packaging: Supplied in 9.0 kg per set.
• Storage: 12 months from manufacture date. Must be stored in original packaging, out of sunshine, at temperatures from 20°C - 40°C.

🧼 Cleaning

• Clean equipment and tools immediately after use with Solvent.

⚠️ Safety Precautions

• Ensure working areas are well-ventilated; use vapor protection masks in poorly ventilated areas.
• Do not expose the working area or materials to naked flames or excessive heat. No smoking.
• Avoid contact with skin and eyes. Wear suitable protective clothing.
• If splashed on skin, wash off immediately with soapy water (do not use solvents).
• If splashed in eyes, rinse immediately with plenty of water and seek medical advice.