KERAGUARD ADG20

Polyurethane UV Resistant Coating

📝 Description

KERAGUARD ADG20 is a high-abrasion-resistant, aliphatic, pigmented polyurethane coating. It is specifically designed for areas subject to high, repetitive abrasive traffic, such as loading docks and aisleways. Being UV resistant, it will not yellow, chalk, or degrade over time, even when exposed to harsh conditions.

📍 Key Uses

High-traffic production areas
Showroom floors
Aircraft hangars
Warehouses
Other areas where physical and chemical resistance, combined with light stability, are important.

✨ Advantages

UV and Chemical Resistant
Good for use on iron and steel surfaces
Non-Toxic and easy to apply
Low maintenance cost
Resistant to Micro-Organism Growth
High Adhesion Strength

📊 Technical Properties

Property	Value
Service Temperatures	-20°C to 80°C
Min Thickness/Coat	50μm
Min Recoat Time	7 hours
Surface drying time	6 hours
Bond strength	≥ 2.0 Mpa
Abrasion strength	≤ 65 mg
Impact Strength	50 kG.cm
Weather Resistance (300h)	No blister, crack, peeling, or chalking. 97% gloss retention.

📏 Coverage

For 100μm thickness: 0.15 kg/m²
For 200μm thickness: 0.30 kg/m²

Applying the Product

1. Surface Preparation

Concrete must be solid with a compressive strength of 25N/mm² and a minimum tensile strength of 1.5N/mm².
The surface must be clean. Contaminants should be removed by chemical and mechanical preparation.
Uneven or damaged areas should be repaired first.
The moisture content in the substrate must be less than 6%.

2. Application Conditions

Substrate moisture content must be < 6%.
Substrate temperature must be between +15°C and +39°C.
Maximum relative air humidity is 85%.
Substrate temperature must be at least 3°C above the dew point.

3. Mixing

Use a slow-speed mixer (no more than 600 rpm).
First, mix Part A for 2-3 minutes.
Add Part B to Part A and mix for another 2-3 minutes until the color is homogenous.
Once mixed, the material cannot be resealed for later use.

4. Application Method

Roller: Apply evenly with a short-hair roller to the desired coverage rate.
Airless Spray: A 20:1 ratio piston pump with a 0.015-inch nozzle may be used. Add up to 5% APT Spraying Thinners to aid application.

5. Limitations

To ensure a homogeneous color, use materials from the same production batch in one area.

🕒 Curing

Temperature	Walking	Light Traffic	Full Traffic
+10°C	24 h	3 days	10 days
+20°C	18 h	2 days	7 days
+30°C	12 h	1 day	5 days

📦 Storage & Packaging

Packaging: Supplied in 18kg per set.
Storage: 12 months from manufacture date. Must be stored in original packaging, out of sunshine, at temperatures from 20°C - 40°C.

🧼 Cleaning

Clean equipment and tools immediately after use with Solvent.

⚠️ Safety Precautions

Always wear gloves, appropriate work clothing, and a respirator when necessary.
Ensure good ventilation, especially in confined areas.
Be cautious with flammable liquids and keep sources of ignition away.
Store resins and hardeners separately.
Consult the Material Safety Data Sheet (MSDS) before handling.
These products are for industrial and professional use only.

APT KERA SEAL ADG20